grantman
1st November 2009, 20:04
Hi
I have been working on the D2 for my son
It was spilling fuel out of the carb
I took off the carb cleaned everything and adjusted the float a bit
Now it runs for a while but it doesnt rev
If I try to rev it it stalls
I think I must have gone to far with the bending of the float spring and it maybe staving of fuel.
Is there a setting in mm I can use?
any tips ?
Thanks
I have been working on the D2 for my son
It was spilling fuel out of the carb
I took off the carb cleaned everything and adjusted the float a bit
Now it runs for a while but it doesnt rev
If I try to rev it it stalls
I think I must have gone to far with the bending of the float spring and it maybe staving of fuel.
Is there a setting in mm I can use?
any tips ?
Thanks