Alloy welding in Wellington?

[quallman1234]

I've got a flywheel cover off a DRZ400 which has had a encounter with a tree.

It was previously welded up (very averagely) and still leaked a bit. A resin was put on the inside what didn't stick to the ally properly (Chips off). So i figure i'll get it welded up properly.

Any suggestions for a cheap, good ally welder in Wellington/Lower Hutt?

Cheers
Kyle

[Crasherfromwayback]

I've got a flywheel cover off a DRZ400 which has had a encounter with a tree.

It was previously welded up (very averagely) and still leaked a bit. A resin was put on the inside what didn't stick to the ally properly (Chips off). So i figure i'll get it welded up properly.

Any suggestions for a cheap, good ally welder in Wellington/Lower Hutt?

Cheers
Kyle

Have you priced up a new cover mate?...sometimes they're not that steep. I'll price one up for you tomorrow if you haven't already.

Pete

[quallman1234]

Have you priced up a new cover mate?...sometimes they're not that steep. I'll price one up for you tomorrow if you haven't already.

Pete

I found one on Ebay in the US for 100$US + shipping, what was an option.
But the hole isn't massive and probabaly isn't far off not leaking, so i figured i'll try do something before i spend that kind of money.

But if you have some time tommorow that would be great! Its a DRZ400E 04' Cheers mate!

[CookMySock]

You can get them alloy-brazed up too, and then take to them with the belt sander and they come up pretty good.

Steve