PDA

View Full Version : Anyone got an STM clutch tool?



Tony.OK
24th April 2010, 13:39
Just after an STM clutch tool for tightening up a clutch basket.

It looks like a large 36mm nut, its to tighten a clutch basket.

Fits into pictured fitting so ya can torque up the clutch basket.

hmmmnz
26th April 2010, 16:58
buy a m24 bolt and a couple of nuts, lock the nuts together, and then use it to tighten your clutch,
(kind of like when you split your forks apart)

Tony.OK
27th April 2010, 00:57
buy a m24 bolt and a couple of nuts, lock the nuts together, and then use it to tighten your clutch,
(kind of like when you split your forks apart)

Cheers, yep sorta gone that way. Got a 35mm nut to go in there and a 35mm socket to put on the torque wrench, needed a nut because the shaft its going onto comes through a bit.

Cheaper than $100US + for the proper bit haha.