explode64
17th November 2010, 08:10
Hi All
Does anyone in NZ do the RGV250 powervalve modification where a machined pin is pressed into the powervalve center. It is the moficication commonly seen on the http://www.rgv250.co.uk/forums web site where there is a pin that has 2 3.75 lugs either side of a 9mm centre that is pressed into the centre powervalve part that is drilled to suit the 9mm part of the pin.
Does anyone in NZ do the RGV250 powervalve modification where a machined pin is pressed into the powervalve center. It is the moficication commonly seen on the http://www.rgv250.co.uk/forums web site where there is a pin that has 2 3.75 lugs either side of a 9mm centre that is pressed into the centre powervalve part that is drilled to suit the 9mm part of the pin.