Wired1
13th September 2006, 20:27
Ok fixed the problem now...
Squiggles
15th September 2006, 23:43
what was it in the end? (i opened this thread and before you edited it and only just got round to reading it)
Wired1
16th September 2006, 17:40
It's a bit embarrassing, the front cam sprocket was missing the sheer pin so was rotating on the cam shaft without turning it - fortunately both valves were closed so no damage, just wouldn't run. I was a bit surprised it wouldn't start with one cylinder but I guess it would be hard work pushing the other piston into a sealed hole!. Runs smooth now.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.