Fly wheel puller & Clutch basket Tool

[montsta56]

Hey People.
I'm in the process of rebuilding the bottom end on an NSR250 MC21. Can anyone shed any light where I can get the above tool's from?? I've seen how to make both part's but I'm hoping to be able to just buy them.
Would a Super cheap/ Repco fly wheel tool work??
Cheers

:niceone:

[dhunt]

If it's anything like the one on a GSXR400 a "balance shaft puller" from Repco works.

See this thread of mine for details

http://www.kiwibiker.co.nz/forums/showthread.php?t=39232

[Taz]

I assume you don't have a compressor and a rattle gun? Does away with the need for the clutch holder tool. Most motorcycle shops will be able to sell you an aftermarket two stroke flywheel puller at a reasonable price.

[montsta56]

Hey Anthrax
MAte i've got a compressor but no rattle gun will this work with out needing to hold the inner clutch basket???
Cheers

[Taz]

sure will. (as long as you have folded down the tab washer) brrrr brrrr and it's off. Oh just an aside...... Leave the plates in the basket as you do this and apply a little pressure to the clutch pack as you rattle the nut off. This stops the inner basket spinning.
Andy.