Wired1
26th April 2008, 17:42
Short term problem is I need the numbers off the kickstart oil seal on a TT500 G, I can't read the original seal and my measurements without taking it out make it look like 12-24-7 but I'd rather be sure than guess. I don't want to take it out until I have the new one as I think I can do it without draining the oil etc (lazy bastard).
Also, does anyone have a list of bearings and seals required for a TT500 overhaul? I'd rather have them all here before I start. I just did an XT550 motor up and had to rip it apart, remove all the bearings and seals, make a list, go to the bearing shop, wait for them to arrive, pick them up, take them home and then consult my list again for where they went. It would be a lot quicker and easier if I could get a list and then do the whole job in one weekend.
Also, does anyone have a list of bearings and seals required for a TT500 overhaul? I'd rather have them all here before I start. I just did an XT550 motor up and had to rip it apart, remove all the bearings and seals, make a list, go to the bearing shop, wait for them to arrive, pick them up, take them home and then consult my list again for where they went. It would be a lot quicker and easier if I could get a list and then do the whole job in one weekend.