Hi, my ZXr250a isnt idling properly, if i adjust the idle screw it will just go up too far or drop down untill it stalls, the revs also move around abit whens its idling aswell. And the revs dont drop back down when you rev it as quickly as they should. My boss said it could be an air hose or a vacuum hose.
Any help would be much appreciated cheers.
The instructions are simple...
A common cause of those symptoms is running lean. Often because of an air leak, usually where the carbs meet the manifold. Sometimes it can be the mixture screw/s need adjusting.
Avoid arguments about the toilet seat by using the sink...
Decal service available. Most makes/models are possible.
Race numbers. Sponsors logos.
Straight forward computer-cut signs.
Heatpress for those t-shirt ideas
Fair weather rider
i had this problem or something similar read this
http://www.tecpeltier.com/viewtopic.php?f=16&t=61
Jam and tarts....
Check for air leaks.
Split hoses, perished rubber.
Check the slides in the carbs move as they should (youtube is your friend)
If this is all nice,
Clean and balance the carbs.
Life does not give you lemons, lemon trees do.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks