Right here's the finished design for the rearset/ footpeg position adjuster plates.
Any productive ideas to change the design are welcomed before i make a batch next week.
See the pics for a better explanation than i can type. but basically you get an adjuster plate the two mounting bolts and 2 linkage rod extensions to allow for the setting you choose to run with.
I can also make up custom length linkage rods and will be making a batch of std length ones as i know they always get bent/ broken.
The plate gives basically 6 options for alternate postions from std in incraments of 20mm. (either 20mm back or 20mm up or 40mm back or 40mm up etc).
They weigh in at a little more than i would have liked at 200g with all the fitting components included but i fear that if i waste any more fom the design it may become too weak and fail too prematurely, altho if requested i can try and waste more out to bring weight down but i doubt it would be much, 50g max.
Give me an indication on what price you would put on these per side. The pics are of the last prototype and the finished design will have a better finish but i ran out of materials to do another proper run to display. (Materials are on their way next week).
The other side would be "as this side" and would be supplied without the linkage rod adaptors. I plan to make all components available seperatley to make for economic repair if required.
Cheers,
your feedback is much appreciated
Olly
Bookmarks