Hi
Does anyone know who can make up a small end bush from the correct materials for a racing dirt bike engine (4 stroke)?
Thanks
Hi
Does anyone know who can make up a small end bush from the correct materials for a racing dirt bike engine (4 stroke)?
Thanks
Oh. Read 'small end bush' and my mind went somewhere else. Carry on.
Grow older but never grow up
Most competent general engineering shops should be able to make and fit a bronze bush - and even get the clearance close.
Icing on the cake is the ability to check the rod for twist and alignment.
You can likely buy them ready made, Carrilo rods and others had bronze bushes std.
http://www.cp-carrillo.com/p-30878-rods.html
Aluminum/ Silicon/ Bronze
C642 Aluminum Bronze
Something less exotic is C932 Bearing Bronze .
What are the dimensions you are after?
http://www.aucklandbearings.co.nz/?a...ype&types=5000
In Auck try this guy
http://www.kiwibiker.co.nz/forums/me.../19368-RMS-eng
re: Small end bush
thats nasty. Tell the bitch to shave
Piss off out of threads about motorbikes and go back to animal porn.
http://hoeggerfarmyard.com/wp-conten...ggershear1.jpg
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks