I couldn't tell the model looking at the engine but the dash in the box makes me think NC24.
speaking of NC30 project bits I & I have:
A frame with VIN and plate which has rego on hold.
A front end (needs work but I think all there and usable.... forks, triples, wheel, axle, brakes clipons.
a subframe
a swingarm complete.
at least one complete loom
fuel tank black/red: quite usable.
a front fairing: aftermarket and not pattern: it kind of looks ZXR750-ish. good condition though not mint.
a single seat tail fairing with cutouts for lights. I think it is just fairings but dont quote me (NC30).
a rider seat.
two fish bins full of bits.... not motor bits they have all gone. I will spread that shit out on the garage floor and see what is there.
I dont know what happened to the 18 inch rear rim I had: I may have sold or given it away.... otherwise I could advertise it as a roller.
Aaaaanyway. I am going to start putting all that shit on tardme this weekend but if any of you want anything specific sing out and I will have a look.
I thought elections were decided by angry posts on social media. - F5 Dave
Hi Henry
Would you sell the swing arm hub/axle unit seperately? (They fit my 750, wanna turn mine into a single nut wheel fitting instead of the 4 nut*)
I think I would need the brake caliper braket as well ....if your keen, I will do my research and confirm the parts required
*Really wanna put a Duc rear wheel on her to allow for better choice in tyre's (current tyre profile has limited tyre options)
THANKS HENRY!!
When Life thows me a curve
...I lean into it!
Hmm, I have almost an engine in my garage amongst other things... These would be handy but I doubt the missus would be happy to have more parts lying around lol.
On another note, I have a RVF gear set amongst my parts (they came with the bike) does anyone know if they are a straight fit into the NC24 gearbox? I would think not but it would be nice to shorten that uber long first gear down a bit.
If anyone has some clutch bits I'd be keen. Haven't taken to mechanic yet but online guesses point to replacement plates and maybe basket? as when I put i first gear with clutch in engine revs drop slightly, as well as generally hard to change gears 75% of time...
Sent from my iPhone using Tapatalk
clutch parts are wear items like brake pads. measure the stack height and see if it is in spec.. If not your steel plates are probably OK but the fibre plates are fucked.
While you are there get a new clutch cable too.
www.davidsilverspares.co.uk
I thought elections were decided by angry posts on social media. - F5 Dave
SCORED!!
...been looking for headlight guards due to all the road works n gravel round ChCh (I now have a few stone chips on the current headlight due to it) so I don't have to replace a broken & rather expensive headlight...bout $300 second hand, or over $600 new from ebay
-Headlight guards?...like finding friggin chicken teeth! (was about to try & make some)
...but look what just arrived in the mail (Good nick, no chips etc and it even came with bulbs!)
http://www.trademe.co.nz/motors/moto...-322998256.htm
$35 delivered! (if it was a KBer...THANK YOU!!)
When Life thows me a curve
...I lean into it!
Complete imported (not vinned) NC30 that's been sitting in the back of some chaps shed for awhile.
Be a good deal if it goes cheap.
http://www.trademe.co.nz/motors/moto...-757668542.htm
Anyone got some nc30 valve shims?
How much were they out of interest? I probably need a full set :/
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks