Hello,
I have a 94' RF600R,I went out to the garage to fire my bike up,before that it had been sitting for roughly a week and topped off with 93 oct. fuel and 5 ounces of seafoam to clean the carbs up(which I hope that didn't screw anything up) .it started right up but then right after that it started to cut out real bad and pop through the exhaust,and a very strong smell of gas,so I shut it off went back out to the garage sometime later started it again did the same thing but then it came out of it and was running smooth and this has pretty much been the scenario for the last couple of days,also the guy I bought it from put a(Stage 1 Dyno jet kit in it) so he said and he seems to think that problem is with the the floats and needle valves and if such is the case and the bowls are loaded with fuel would it not be leaking and there be fuel on the ground? or if there is no place for the fuel to go in which case it is staying in the bowls and causing the above problems? I apologize for the long paragraph,this issue is really driving me nuts and any help would really be great.
Thanks Dave.
Bookmarks