Anyone know where I can get suitable o rings for the pilot screws on your carb. I tried bay engineers supplies and they had nothing that small. I'm not keen to order in a genuine one on back order and wait a month either.
Anyone know where I can get suitable o rings for the pilot screws on your carb. I tried bay engineers supplies and they had nothing that small. I'm not keen to order in a genuine one on back order and wait a month either.
Para rubber used to carry o rings, Don't know if they still do or if they would have anything that small.
What sort of diameter?
About 5.5mm outside diamerter. 4mm inside diameter
Super cheap autos do a box of O-rings for around $8. In the socket set section somewhere, in the UH shop anyway.
Some things are worth dying for, living is one of them.
You want a small 'o' ring?
It has to be said,
"Don't go to prison"
They shall not grow old as we that are left grow old.
Age shall not weary them nor the years condemn.
At the going down of the sun and in the evening,
we will remember them
Slopster I may have one that may be suitable. You can pop around and grab it if you like?
That looks about right Bonez but I need 3 of them (Didn't realise there were o rings behind the pilot screw till they went down the drain while cleaning my carb) bugger!
I'll have another gander out in the play pen. Be back in a tick.....................Originally Posted by slopster
No luck sorry. Have you pulled the sink drain U tube off to see if they aren't in it?
Measure it up & ring Shuk Engineering Distributors 06-7588300. Pm me if you want them picked up & couriered.
Suck, Squeeze, Bang, Blow arent just the 4 cycles of an engine
You will need it made of some material resistant to petrol, or it will melt and mush it's way through your carb.
Viton is the material of choice, and the last ones I brought cost about $8 each.
At the rise of the hand by Policeman, stop rapidly. Do not pass him by or otherwise disrespect him.
Cg is right, you can get them made out of different material, got my last ones from pacific seals, cost me about 80c they will be able to tell you what material the "o" ring should be made of, same with brake fluid and any chemical,
In thrust we trust
Yeah I mannaged to get some from Engineering Plastics after I tried just about everyone else in town. Got them made of Viton as well.
That's handy to know. Thanks for sharing.Originally Posted by slopster
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks