Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums Articles Articles Blog Blogs
  • george formby's Avatar
    Today, 13:57
    If you get the runaround in Whangas BK, I did, their is a bloke just down the road from me who is a black belt auto sparky. I sent off my DT...
    15 replies | 210 view(s)
  • richban's Avatar
    Today, 13:42
    richban replied to a thread Race chassis in Buckets
    Top tip. Will do.
    1097 replies | 111965 view(s)
  • Grumph's Avatar
    Today, 13:34
    Grumph replied to a thread Race chassis in Buckets
    Never used or needed one of them. A good eye and steady hand with a disc grinder will do most of it - and a good selection of round and half round...
    1097 replies | 111965 view(s)
  • Reckless's Avatar
    Today, 13:31
    Still on hold by the looks of this only published yesterday?? http://amcn.com.au/editorial/kiwi-controversy/ Anymore updates lads???
    29 replies | 835 view(s)
  • pritch's Avatar
    Today, 12:41
    pritch replied to a thread MotoGP 2017 in Racing
    Don't sweat it. The conditions were described as "very very" slippery so may or may not be irrelevant to the race. Dorna were still discussing...
    340 replies | 16709 view(s)
  • Akzle's Avatar
    Today, 12:33
    some hot-off-the-press advice, don't drive through town today, i dont know who put what in the water supply, but there are some fucken crackhead...
    15 replies | 210 view(s)
  • katinas's Avatar
    Today, 12:32
    katinas replied to a thread ESE's works engine tuner in Buckets
    Russian outboard engine Vihr 30 (Whirlpool 30), modified copy of Germany 1957 Konig (http://quincylooperracing.us/gpage8.html). Two cylinders, 488...
    25518 replies | 3824716 view(s)
  • Autech's Avatar
    Today, 12:16
    Autech replied to a thread MotoGP 2017 in Racing
    He is mad joe after all... Lol. New predictions: MV DP MM AD JL VR CC
    340 replies | 16709 view(s)
  • nzspokes's Avatar
    Today, 12:15
    nzspokes replied to a thread ad - Bike MT 09 with $3500 of extra mods in Online Trading
    Ive had the same. 2 of them out by the airport go nuts each time they see another rider. Odd.
    3 replies | 138 view(s)
  • richban's Avatar
    Today, 12:04
    richban replied to a thread Race chassis in Buckets
    That was the plan. Still is. The bit I had was 60.3 x 3.9mm. The plan was tidy up the inside 30mm in the tin the outer to make 2mm wall. Good to know...
    1097 replies | 111965 view(s)
  • Mike.Gayner's Avatar
    Today, 11:56
    Evidently English isn't your strong suit. See here:...
    13 replies | 541 view(s)
  • Grumph's Avatar
    Today, 11:48
    So the Republicans "didn't have the numbers" to get Obamacare repealed. Funny when you control both Houses. Maybe they'd been listening to...
    3715 replies | 108053 view(s)
  • MarlinHemi's Avatar
    Today, 11:43
    MarlinHemi started a thread ad - WTB Canterbury project bikes in Online Trading
    any projects in canterbury that don't need major work? cheers
    0 replies | 15 view(s)
  • aws's Avatar
    Today, 11:38
    Don't know much about the hot alternator, but I'd expect you could go about 1.5 hrs on a good fully charged battery in daytime. I once drove an old...
    15 replies | 210 view(s)
  • Seraph's Avatar
    Today, 11:34
    I'm sorry for the confusion but you're bike is LAMS approved as its under 250cc and not on the prohibited list. Before flaming people for...
    13 replies | 541 view(s)
  • Grumph's Avatar
    Today, 11:33
    Grumph replied to a thread Race chassis in Buckets
    You don't need a fully machined one piece headstock. A piece of largish OD MS tube say 2mm wall with the ends squared will do. Then you make up...
    1097 replies | 111965 view(s)
  • YellowDog's Avatar
    Today, 11:20
    apparently alcohol is good for your engine: <iframe width="860" height="485" src="https://www.youtube.com/embed/jdW1t8r8qYc" frameborder="0"...
    1229 replies | 110476 view(s)
  • pritch's Avatar
    Today, 11:15
    pritch replied to a thread MotoGP 2017 in Racing
    He put soft tyres on but it's doubted that he can use them in the race. That and he's never been short of bravery?
    340 replies | 16709 view(s)
  • katinas's Avatar
    Today, 10:37
    katinas replied to a thread ESE's works engine tuner in Buckets
    Hi So, after very busy preparation day ( all that road legal stuff is so boring: head lamps, turns, mirrors, insurance ), but in the end ride...
    25518 replies | 3824716 view(s)
  • EJK's Avatar
    Today, 10:26
    EJK replied to a thread MotoGP 2017 in Racing
    In the past season he's always been quick on the clock but struggled during actual racing when things go aggressive and traffic is in the way. If he...
    340 replies | 16709 view(s)
  • richban's Avatar
    Today, 10:20
    richban replied to a thread Race chassis in Buckets
    Much thanks. Will give them a bell next week. No tail stock rpm way high. Disaster waiting to happen really. Learning some lessons so thats a plus.
    1097 replies | 111965 view(s)
  • Ultralightweght's Avatar
    Today, 10:14
    Ultralightweght replied to a thread Race chassis in Buckets
    I'd use 1040 or 1030 grade- or phone milson metals and get some hollow bar - save heaps of time machining-the next thing to check is the tool...
    1097 replies | 111965 view(s)
  • Pound's Avatar
    Today, 10:10
    Pound replied to a thread ad - Bike MT 09 with $3500 of extra mods in Online Trading
    Indeed, I think it's the type of bike that hooligans like to ride... :) But you wont see me trying that sort of thing, never raced anybody, and...
    3 replies | 138 view(s)
  • Dadpole's Avatar
    Today, 09:53
    Dadpole replied to a thread MotoGP 2017 in Racing
    I gather the starting problem was mainly down to the Suzuki as Asparagus had issues on it too. Interesting FP3 though. In Moto2 the VDS team look...
    340 replies | 16709 view(s)
More Activity