Oil line fittings

[ducatilover]

I am having trouble sourcing fittings for an4/an6 stainless braided lines. I need ends to suit a toyota ct12a turbo and a tee joint for the oil pressure switch , the top and bottom need to be a thread tapered 10mm - 9mm and the tee out the side to be suitable for any an4 or an6 fittings. It is obviously for my turbo project :Punk: Any advice would be good thanks

[pete376403]

TWIGG W R (WELLINGTON) LIMITED
Distributors of Engineering & Transport Equipment
Address and contact details
31 Railway Ave Lower Hutt 5010
PO Box 31402 Lower Hutt 5040
NEW ZEALAND
+64 +4 570 6688

Last time I was in there they had a pretty good range of fittings

[ducatilover]

Thank you very much, bling awarded. Will give them a ring :done:

[motorcyclesonline.net]

Have a talk to the guys at Autokraft, they should be able to sort it
Regards
Bill
www.motorcyclesonline.net



I am having trouble sourcing fittings for an4/an6 stainless braided lines. I need ends to suit a toyota ct12a turbo and a tee joint for the oil pressure switch , the top and bottom need to be a thread tapered 10mm - 9mm and the tee out the side to be suitable for any an4 or an6 fittings. It is obviously for my turbo project :Punk: Any advice would be good thanks