Log in

View Full Version : SV650 parts



Sensei
27th March 2005, 22:20
Hi have 4 parts for SV650 99-02
Full Yoshy system {Ti Muffler } $900 the lot {Muffler alone $1150}
K&N Filter $80
Rear Hugger $150
Radiator Guard $100
Or Buy all of these together for $1100

Will be putting them back onto Trademe soon PM if your are keen to buy any bit's
Scott

GSVR
29th March 2005, 12:44
Hi Scott,

Is the can an Oval or Tri Oval one. Its hard to tell from the picture.

I have seen the auctions on Trade Me and $800 is as high as I was prepared to go.

Also this pipe wouldn't make the bike to loud to pass a warrant would it?


Regards Garry

Sensei
29th March 2005, 17:53
Hi Garry Muffler is Oval Titanium $1150 just for muffler .$2500+ complete system , Fucken cheap so are all the other bit's . The owner has asked for them back so want be putting them back on auction again by the looks . Exhaust was on his wife's 2001 SV650 no worrys with WOT about been loud . If keen to buy find an Xtra $100 dude System has been Pro polished back to Mint look's & sounds fantastic . PM me
SENSEI

snozymotto
1st April 2005, 21:37
Does your SV650 Hugger fit a Sv1000? If it doesn't do you know where I can get one?

Sensei
1st April 2005, 22:26
Hey SM nope tyre is only a 160 not like the 190 on the SV1000 . There was one on Trademe this week so check out in Bike parts
SENSEI

cliffy
2nd April 2005, 10:50
hey guys, i have an sv 650 frame swingarm (incl linkages etc)and rear shock and subframe incl underseat trays etc to throw into the mix if anyone wants to build a bike out of all the bits listed on this thread :2thumbsup . had'nt planned to sell it but if the price is right......well s'pose i would. oh its an 03 too i think?( the square section frame.)

GSVR
2nd April 2005, 11:19
hey guys, i have an sv 650 frame swingarm (incl linkages etc)and rear shock and subframe incl underseat trays etc to throw into the mix if anyone wants to build a bike out of all the bits listed on this thread :2thumbsup . had'nt planned to sell it but if the price is right......well s'pose i would. oh its an 03 too i think?( the square section frame.)


Is like like this one ?

http://www.trademe.co.nz/Trade-Me-Motors/Motorbikes/Motorbike-Parts/Frames-suspension-bodywork/auction-21926677.htm

I think it would be very hard to source all the bits to turn it into a runner.

GSVR
2nd April 2005, 11:28
Sensei 509

Fitted the system on the bike.

Was a bit shocked when I fired it up but it put a smile on my face.

Looks good and sounds awesome thanks.