ajw_888
27th October 2009, 07:24
My supermoto has a tokico (ZX635, ZX10, gold colour) fitted, the back side has been cut back to clear the spokes, as is normally done, but I suspect one half may have been machined down a little on the inner face.
Could someone please measure either, the inside faces where the pistons go into the body ( nice flat surfaces) or even the outside dimension of the pad retaining pin area. This will give something to check back on mine.
cheers
Could someone please measure either, the inside faces where the pistons go into the body ( nice flat surfaces) or even the outside dimension of the pad retaining pin area. This will give something to check back on mine.
cheers