Parts needed!!! (CBR250RR)

[Coyote]

If I wanna make it for round 2, I need to get:

-Front brake resevoir/lever assembly
-RH Crankcase cover
-Nitrous Oxide kit :shifty:

Also, I'm looking for a front fairing. I wanted to try make my own out of fibreglass (with no skill or experience of course) or buy a fibreglass fairing. Could anyone lead me to a good DIY fibreglass site or to companies who sell fibreglass replacements cheap (Already aware of Just Fairings, just want to know who else is out there)

[bugjuice]

http://www.justfairings.co.nz/
would be a good start.
Wrecking yards would be the best bet for the crankcase and brake stuff. Shouldn't be too much all up for those two

[Sparky Bills]

I may be able to help with a brake M/cyl and lever assy.
Off a CBR600, but should fit good as gold.
Give me a PM if interested.
Cheers.
Martin

[Kwaka-Kid]

Stuff jsutfairings man! Ala where are u located dude? its funny you should mention this as i know of where a set of moulds for CBR250RR race fairings are and im sure itll work out cheaper if i can get a mate to run you a set or summit, infact might have a set in stock.... will get back to you.

[SPORK]

Stuff jsutfairings man! Ala where are u located dude? its funny you should mention this as i know of where a set of moulds for CBR250RR race fairings are and im sure itll work out cheaper if i can get a mate to run you a set or summit, infact might have a set in stock.... will get back to you.
I'm bored and nosey so I'll answer for him.

He's down in Upper Hutt. About 2 minutes from me :O

[justsomeguy]

Stuff jsutfairings man! Ala where are u located dude? its funny you should mention this as i know of where a set of moulds for CBR250RR race fairings are and im sure itll work out cheaper if i can get a mate to run you a set or summit, infact might have a set in stock.... will get back to you.

Can your mate do the same for a ZZR250?? Not race just road fairings......