SILVER SUZI
3rd February 2010, 09:05
The headstock on my 04 R1 keeps coming loose: :argh: And as I dont have C spanners I keep using a bar and hammer to tap the two nuts tight again. Twice I have asked the guys where I get the bike serviced to have a look at this and twice they have said they can find nothing wrong. I pulled it halfway apart last night, not marks on the inside of the top bearing race so I will put it all back togeather. So what I need to know is this. If I simply get two C spanners tighten the bottom nut up and tighten the top nut up against it properly will it stop coming loose? What kind of grease should I use in there (and where would I get it)? I know nothing about packing bearings so I work on the "theres no such thing as too much" principal. Oh and is there any way of knowing how tight to do up the first nut?
Any advise will be appreciated.
Any advise will be appreciated.