roenut
12th November 2010, 19:33
hey people, i just got hold of some inverted shocks, brakes and wheel off a crf500.
im trying to fit them to my 95 xr250. the center/pivot shaft is the right size for the top bearing, but widens slightly at the bottom.
has anyone done this conversion yet?
i may get the shaft machined down at the bottom so i can use my xr250 ball bearings as i dont think the tapered bearing cones will fit my subframe.
any help would be hugely appreciated!!!!
im trying to fit them to my 95 xr250. the center/pivot shaft is the right size for the top bearing, but widens slightly at the bottom.
has anyone done this conversion yet?
i may get the shaft machined down at the bottom so i can use my xr250 ball bearings as i dont think the tapered bearing cones will fit my subframe.
any help would be hugely appreciated!!!!