View Full Version : WANTED: ZXR400H1 swingarm
sharky
15th November 2010, 08:09
Hi, as the title says - looking for a 1989 ZXR400H1 swingarm (the one with the brace)
Cheers
sharky
18th November 2010, 06:15
All sorted:yes:
bistard
18th November 2010, 06:53
All sorted:yes:
Thats good, I have just done the same modification to my ZXR, Warning though,
the axle size is bigger on the later bikes,so you might need to file out the axle slots &
the chain adjuster blocks need to be turned around also
So check the axle size & make the hole bigger before putting it in the bike,makes it much easier,trust me
Bistard
sharky
18th November 2010, 10:10
Thats good, I have just done the same modification to my ZXR, Warning though,
the axle size is bigger on the later bikes,so you might need to file out the axle slots &
the chain adjuster blocks need to be turned around also
So check the axle size & make the hole bigger before putting it in the bike,makes it much easier,trust me
Bistard
Cheers mate. Yeah am aware of the axle issue - other than that does everything else fit straight on no drama? Spacers, brake habger... etc?
bistard
18th November 2010, 10:28
Cheers mate. Yeah am aware of the axle issue - other than that does everything else fit straight on no drama? Spacers, brake habger... etc?
yes, everything else fits fine,dont forget to lube all the shock linkages,while you are there
I am now loking for a hugger, as the later model one does not fit,so if you find a couple let me know
Regards
Barry
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.