BOGAN02
29th December 2010, 18:38
Well im in need of a sheet metal worker in the B.O.P. region. Ive got an old norton tank and the original tank from my bike, and i want to make one out of the two.
I know how to weld and shit but i havnt done a tank before. Was wondering if i could get the advice of a fellow KBer to help me make this tank mean. The tank i want on my ride is an old ass 1949 Norton fuel tank. The original tank is Off my XS250 RK. So im pretty much looking for some one with the know-how to build a tank out of the 2. Im needing the mounting points from the xs tank as they already fit the frame. But the norton tank is about the same size but alot heavier(and thicker steel) and is a bit on the thin side where it sits over the frame. So if someone could give me any advie bout this prob it would be great.
I know how to weld and shit but i havnt done a tank before. Was wondering if i could get the advice of a fellow KBer to help me make this tank mean. The tank i want on my ride is an old ass 1949 Norton fuel tank. The original tank is Off my XS250 RK. So im pretty much looking for some one with the know-how to build a tank out of the 2. Im needing the mounting points from the xs tank as they already fit the frame. But the norton tank is about the same size but alot heavier(and thicker steel) and is a bit on the thin side where it sits over the frame. So if someone could give me any advie bout this prob it would be great.