B&B rear rack on XT250

[nic]

hi there

I am putting a B&B rack on my XT250, but I have come to a halt 'cause I cannot work out how to disconnect the indictors without cutting wires (which I am assuming shouldn't be necessary?!?)

The rack is mounted to the the front grabrail mounts and the indicator brackets.

Any thoughts/ tips would be appreciated...

cheers233299233300233301

[NordieBoy]

Further in should be a connector. The leads should be no more than about 15cm long?

[junkmanjoe]

might have to take your seat off or they might be tucked up under the rear guard..

[cooneyr]

If you trace the wires forward along the frame you should come to some connectors. You may need to cut or undo some zip ties and maybe even remove the tail plastics to get the wires out.

[dino3310]

put it back together and buy a DR:bleh:

[nic]

Thanks guys (not you dino!)

I think the seat will have to come off.

[That looks like fun]

Thanks guys (not you dino!)

I think the seat will have to come off.

I feel your pain Dino :love:
I feel ya pain

[nic]

Seat off....side fairings off......connectors found.....indicators diconnected.... nearly there :D

and I found the air filter, which I was looking for :niceone:

thanks again for your comments (not you dino).

[Taz]

Well done chub!! :clap:

[junkmanjoe]

on ya,,,let your fingers do the looking..........:niceone:
make sure you dont have any nuts and bolts left over when your finished..

JMJ