Bike stand/lift

[riffer]

I am looking at getting a bike stand for my Fizzer, as its a pain in the butt using two scissor stands from cars to lift it up every time I want to do the chain etc.

I'm looking at something like an Anderson stand, but Repco also has a hydraulic lift available for around $280 (Chinese, I imagine).

Can any of you point me in the right direction?

AFAIK, I don't have threaded bosses on my swingarm so I will need a universal-type stand.

[bluninja]

If it's just for doing the chain get something like a tommy jack...I think motomail do a little stand as well. You just lean the bike over on the side stand and stick the device under the wingarm on the opposite side. It's enough for lubing the chain, otherwise a universal rear stand will do the job nicely...and then you can remove the rear wheel as well if you want.

TTFN

[Motoracer]

Reffer to this post:

http://www.kiwibiker.co.nz/forums/showthread.php?s=&threadid=430

They are awesome stands! :niceone: Most of the top racers are using them and they fit almost any bike if not all.

[riffer]

Woohoo! You little beauty!

Cheers for that motoracer. I guess I don't have to save up my money after all...

[wkid_one]

You can by my rear stand off me - has both universal and bobbin pickups - make me an offer