Fork straightening?

[celtickiwi]

does anybody know any good engineering shops where i can get a pair of forks straightened,prefer chch area but any where will do cheers

[tigertim20]

does anybody know any good engineering shops where i can get a pair of forks straightened,prefer chch area but any where will do cheers

Id suggest getting new forks . . .

[Kickaha]

does anybody know any good engineering shops where i can get a pair of forks straightened,prefer chch area but any where will do cheers

Anyone who can use a press 1/2 way decent could do it, what are the forks off and how bad is the bend?

Otherwise send them to F1 engineering (http://www.rapidartnz.com/Services/ForkS.htm)

[Grumph]

Barry Lynch at Beaumont Eng over by Wigram will tell you if it's feasible and do them at reasonable cost too.

[Kickaha]

Barry Lynch at Beaumont Eng over by Wigram will tell you if it's feasible and do them at reasonable cost too.

How long will he have to wait though :whistle:

[Robert Taylor]

If they are creased its new tubes. Its not only a matter of having a press its also about having all the right formers and only people that are geared up to do it will have those. I cant answer for the South Island but here in the North Island F1 Engineering are the very best. Anything thats a little more involved than straightforward straightening we send there.

[celtickiwi]

Anyone who can use a press 1/2 way decent could do it, what are the forks off and how bad is the bend?

Otherwise send them to F1 engineering (http://www.rapidartnz.com/Services/ForkS.htm)

forks arent too badly bent just a couple of mill but one is slightly more than the other, hence the bike loves left handers but not too keen on right handers off a kwaka zxr750 h1

[celtickiwi]

Barry Lynch at Beaumont Eng over by Wigram will tell you if it's feasible and do them at reasonable cost too.

cheeers for that ill check him out tomorrow