Better fittings for rgv250 silencers?

[Chancebmx25]

Hey all.

My silencers on my smoker are sweet and all. but i hate the whole spring design its lame.. the springs snap and its just shit having to replace them all the time. id prefer a clamp as so i have seen on a few models. but there to get the fittings for these so my silencers go over the tip of the exhaust and not inside. its becomming a pain slowly.

Any ideas or help on this would be much appreciated. ask if u dnt get what i mean.

Cheers. will post pics if someone can give genuine help so you get what im tryn to say.

[hayd3n]

get better springs?

[Chancebmx25]

get better springs?

got racing springs. but the problem is u need to have good lil fittings that the springs will clip into.. its hard to find them lil clips.. otherwise when its a straight mount the springs wil js heat up and snap, kinda a useless design. but a bolt on clamp would be twenty times better.

[Chancebmx25]

I hate these fittings.. how do i get the clamps.. where do i get them from? the springs just snap and turn to shit. 239124239125

[DrunkenMistake]

Argh your rim tape is all kinky.. doesnt that drive you insane? :woohoo:

[Chancebmx25]

Argh your rim tape is all kinky.. doesnt that drive you insane? :woohoo:

Yes cheap rubbish!

[DrunkenMistake]

Yes cheap rubbish!

I get anal about stuff like that haha, I cant stand something out of place on my bike ae, its not so bad at the moment because the current bike is a little rough around the edges

[Chancebmx25]

I get anal about stuff like that haha, I cant stand something out of place on my bike ae, its not so bad at the moment because the current bike is a little rough around the edges

Yer man im the same i just bought new rim tape precut shit so hopefully it runs around alright, its fkn crappy shit to get perfect would rather a decal specialist do it but that shit cost way too much. Lol

[DrunkenMistake]

Yer man im the same i just bought new rim tape precut shit so hopefully it runs around alright, its fkn crappy shit to get perfect would rather a decal specialist do it but that shit cost way too much. Lol

Epic thread hijack happening here, but did you get the stuff in the dispenser? you can get some shit its in a roll dispenser and you run it around the rim and so long as your rims arnt all square and retarded it should go on perfectly, the precut stuff can be a super prick to match up because its in lots of 4

[Chancebmx25]

Epic thread hijack happening here, but did you get the stuff in the dispenser? you can get some shit its in a roll dispenser and you run it around the rim and so long as your rims arnt all square and retarded it should go on perfectly, the precut stuff can be a super prick to match up because its in lots of 4

In a dispenser aye. I gt that ebay shit. Use less! Id like to get some decent precut or something thatll give me a mean circle

[macros87]

is this what you are talking about? http://www.trademe.co.nz/Trade-Me-Motors/Motorbikes/Parts-for-sale/Other/auction-377227990.htm

I have heard of these zorst guys and they seem alright, i think they make their parts themselves too if you were after something different.