AX100 part needed

[Skunk]

I need the spacer that goes between these two bearings inside the rear hub of a late 80's Suzuki AX100.

I have no idea what it looks like as I only found it was missing when I took the wheel out to change the tyre.

[F5 Dave]

Should be the same as several other small suzukis, problem is who bothers to wreck them?
It is a simple spacer which steps down to the ID of the bigger outboard bearing. Obviously a bigger spacer can be turned down on a lathe.

The length needs to be the same as the distance between the bearings. You can estimate this with a calliper, or with a smaller spacer & some plasticine to squash & measure.

[Skunk]

The length needs to be the same as the distance between the bearings. You can estimate this with a calliper, or with a smaller spacer & some plasticine to squash & measure.Yeah, it was how to measure the length that had me buggered...

Thanks for the idea.