PDA

View Full Version : How do I get water out of the fuel tank?



carbonhed
4th March 2012, 17:34
I replaced the fuel cap on my track bike with a simple screw in type. Damn things not watertight. I've ripped the tank off and removed 99.5% of the fuel but there's still a film around the inside of the tank. I've thought of just leaving it in the sun with the cap off and letting the warmth evaporate what's in there and I've also wondered about blasting compressed air through it periodically... but I'm worried about static electricity and blowing my head clean off.

Any thoughts?

Ocean1
4th March 2012, 17:38
Any thoughts?

Chances of a mixture aproaching lower explosive limit isn't high.

I'd bung a couple of hundred ml of alcohol of some sort, (meths will do) shake it around a bit, dump the mixture and then stick it out in the sun to dry.

BMWST?
4th March 2012, 17:39
leave it in the sun withthe cap off.when you are using the bike pour some meths in to the tank when there is a good ammount of petrol in there(ie no more than 10 percent meths by volume),the meths will absorbthe water and it will pass through the engine/fuel suystem harmlessly

jellywrestler
4th March 2012, 17:54
meths a couple of cups will be fine and just use the biike as normal, meths is a fuel, methanol actually and like has been said it will absorb thge water and burn

FJRider
4th March 2012, 18:51
Just put a few litres of petrol in the tank. Splash it around a bit ... then drain again. Whats left wont be worth worrying about.

carbonhed
4th March 2012, 18:54
Outstanding. Thanks very much guys.

yungatart
4th March 2012, 19:24
Isopropyl Alcohol is the best stuff, if you can get hold of it.

scumdog
4th March 2012, 19:33
leave it in the sun withthe cap off.when you are using the bike pour some meths in to the tank when there is a good ammount of petrol in there(ie no more than 10 percent meths by volume),the meths will absorbthe water and it will pass through the engine/fuel suystem harmlessly

Did an experiment a year or so back.

Put a litre of petrol into a plastic coke bottle.

Added about an egg-cup of water

Added about three egg cups of meths

Shook the whole lot up and it appeared all three had dissolved into each other.

Five minute later thay had all separated into three distinct different layers.

"Your results may vary"

FJRider
4th March 2012, 19:38
"Your results may vary"

Wont be by much ... :no:

Ocean1
4th March 2012, 19:42
Five minute later thay had all separated into three distinct different layers.

In theory Meths, (actually mostly ethy alcohol) is infinitely miscible in water. It may be that the three layers you saw wern't the original three ingredients, not sure.

Flip
5th March 2012, 18:02
The other thing meths does is it forms a semi stable emulsion with the water and the gas, this will be the middle layer.

To get the water to dissolve in the fuel you will have to add more meths than the rubber in the fuel systems can handle.

Simply drain the tank, add some meths, slosh it around, drain and refill with fresh fuel.

BMWST?
5th March 2012, 21:00
Did an experiment a year or so back.

Put a litre of petrol into a plastic coke bottle.

Added about an egg-cup of water

Added about three egg cups of meths

Shook the whole lot up and it appeared all three had dissolved into each other.

Five minute later thay had all separated into three distinct different layers.

"Your results may vary"

too much water not enough meths.....

Coldrider
5th March 2012, 21:25
Five minute later thay had all separated into three distinct different layers.

"Your results may vary"My results varied between a Vietnamese 3 bean drink and a tequila sunrise, both highly drinkable though.:drinkup:

ellipsis
5th March 2012, 21:30
...take it to a servo...put ten bucks more in than the tank will hold...mop off...ride...

SMOKEU
7th March 2012, 19:40
Isopropyl Alcohol is the best stuff, if you can get hold of it.

Jaycar sells it in 200mL bottles.

hayd3n
7th March 2012, 20:13
mek absorbs water but i wouldent use it and i have like 20l at work

98tls
7th March 2012, 20:21
The other thing meths does is it forms a semi stable emulsion with the water and the gas, this will be the middle layer.

To get the water to dissolve in the fuel you will have to add more meths than the rubber in the fuel systems can handle.

Simply drain the tank, add some meths, slosh it around, drain and refill with fresh fuel.

Interesting that,so the old teaspoon of meths everynow and then is just another old wives tale so to speak?

FJRider
7th March 2012, 20:46
Interesting that,so the old teaspoon of meths everynow and then is just another old wives tale so to speak?

So you listen to old wives ... or just one "old wife" ... ???