PDA

View Full Version : Cylinders



cdfeto
22nd April 2012, 19:47
Hi,

are there any places in Auckland where I could get a set of small (43mm) cylinders honed oversize?
And, what would you consider the max I.D and/or out of round of the bore before over-sizing?

The engine is out of a 76 Suzuki GT125.

cheers!

FJRider
22nd April 2012, 20:46
A hone will only polish the bore. Take out minor irregularities ... A re-bore to take them to the next size will be needed. Check pistons to see if they're standard ... or oversize already. It's (usually stamped on the top of the piston)