New tacho glass and cover ring?

[OutLander]

Hi,

Not sure if it that can be done but still. Is there any company, who can сut a piece of glass or plastik with needed demensions?
Thanks.

[hayd3n]

Hi,

Not sure if it that can be done but still. Is there any company, who can сut a piece of glass or plastik with needed demensions?
Thanks.

most shops the store glass or plastic can

[imdying]

Smiths or Mulfords.

[Laava]

I did this successfully before and in my case I was replacing a convex glass with flat that only cleared the tacho needle boss by about 3 sperms. So just something to check.

[tigertim20]

Hi,

Not sure if it that can be done but still. Is there any company, who can сut a piece of glass or plastik with needed demensions?
Thanks.

I am about to do exactly this. get yourselg some perspex or similar, measure the hole and cut it out slightly large, then trim it down to size, checking regularly by gently sandiing it to a perfect fit. Some decent glue designed to be used on the plastics in question will see it stuck fast.

Im using a dremmel for the sanding but Im a lazy cunt.

bit of perspex will cost ya a couple bucks, or free if ya know the right people!

[nodrog]

I can, but i cant be arsed.

these guys can too

http://www.anythingacrylic.co.nz/

[The Lone Rider]

Hope this isn't too off topic...

But I once pulled apart a speedo to do custom speedo plates... the sucker seemed to be stamped and sealed from the factory? It was wicked hard to get it open.

Are they all like that!?

[tigertim20]

just did mine tonight. was easy. just 8 small screws, give it a wiggle, and it came apart.
some shit cell phone pics
266620266621266622266623266624

[tigertim20]

couple extra
266625266626

i left the film on till the glue has dried to avoid getting the new lens marked.
job done, took 15 minutes.