would gpz500 eng fit in gpz400?

[ducatilover]

i have seen a good[ish] gpz500 engine+frame on trademe and was wonering if gpz500/gpz400 bits are interchagable. also would the rear fairing and seat trom a gpz600 fit on my gpz400 cos the bits look to be of the same size.cheers :woohoo: :puke: :rofl:

[nudemetalz]

Well my opinion is that the 400 and 500 engine mounts would be totally different, owing to the fact that one is a four cylinder and the other a twin.

400 and 600 parts should be interchangeable I would think.

I believe GPz400's were essentially 600's with smaller bore and stroke.
But GPz500's are totally different.

Cheers
Chris

[ducatilover]

what about....gpz550, zxr400, zxr600, gpx/anything engines, im getting desperate!!!! gpz400 bits seem pretty few&far between..... :sherlock:

[Bonez]

what about....gpz550, zxr400, zxr600, gpx/anything engines, im getting desperate!!!! gpz400 bits seem pretty few&far between..... :sherlock:Is the gpz400 an air cooled four? If so the aircooled z500, z550, gpz 550 or the zepher 550 motors could be the go.

[ducatilover]

i'll try get a cheap gpz600 engine, if anyone see's anything tell me
thanks so far :woohoo: :clap: :Punk: