F5 GP attendees

[cotswold]

Can you indicate if you are entering an F5 bike as I'm a tight ass and will only get my license if the numbers stack up.

[Dutchee]

Can you indicate if you are entering an F5 bike as I'm a tight ass and will only get my license if the numbers stack up.

That would be a NO from me.

[koba]

If the running is threatened by lack of numbers I'll try and shake something up, getting the licence anyway...

[Skunk]

Don't forget about the $50 special upgrade licence. I believe they are getting this sorted. Can anyone confirm?


If it ain't smokin' - it's broken.

[andrew a]

Hi guys I feel I have missed something. Can someone confirm the date for the GP. Its at Tokaroa a.

[F5 Dave]

8th & GP on 9th Tokoroa in another thread.


So that's you a yes then?


I'm, in of course. Darrin probably, DaveD always. But there are probably others that don't frequent this forum.


But yes lets push to get the numbers up. 6 weeks is enough to get a bit done.

[mr bucketracer]

started today to build a 50 , should take a week and not be to far of going . not the way l nomaly do things but it should go good .. where can i get hold of cheap rg50 pistons

[F5 Dave]

Dunno about cheap but RMX50 were the same

[Gigglebutton]

Worked on the RG today
Rebuilt the new front brake caliper. Now it works and doesn't drag when you release the lever.
Welded the gear lever and made a new adjuster rod.
Replaced the well used bits of plastic.
Put all the levers back where I like them.
Put air in the tires , oiled the chain, mixed some fuel and put it in the tank.
I pushed it up the hill 3 times and the F*^@#er wont start :angry:
Off to see TZ and the ESE dyno next week to see if they can get it to go.

[F5 Dave]

3 steps and they should be running. Check spark and gas blockage.

[Gigglebutton]

Probable the rota. It,s a bit shagged . I had to glue it on.
May have to weld an insert in and recut the taper

[F5 Dave]

Stock ign is woeful. CDIs known to fail

[mr bucketracer]

Gigglebutton..... is it stock or got the small flywheel mx set up ?

[Gigglebutton]

Gigglebutton..... is it stock or got the small flywheel mx set up ?

Its got a small rotor and an ignitech. Needed the twin curve ignitech to run the NOS. I got a guy that owed me a few favors to machine the the taper as I was to busy. He got it very slightly wrong. Did not realize as I gave it to my nephew to ride and did not pick it up

[mr bucketracer]

so who's racing the 50s, 100f ? f5 dave , giggle , regan , cotswold , henk , dave d , darran g? , andew a , ricks son ..who else ESE boys buckets for me 14hp joby

[koba]

so who's racing the 50s, 100f ? f5 dave , giggle , regan , cotswold , henk , dave d , darran g? , andew a , ricks son ..who else ESE boys buckets for me 14hp joby

I am......

[Henk]

Yep .

[mr bucketracer]

looks like going to be a good turn out .. a poll koba or is there no one wanting one for giggle