Torque specs GSX250 Invader exterior I.e. swing arm?

[spoonguard]

Heya, this is my first post here. I am just doing a project atm of rebuilding my gsx 250 the frames been stripped down and powder coated yada yada blah blah. And I am getting ready to assemble and I thought I might just swing past and ask about any important torque specs I should know of for exterior parts I.e. engine bolts connecting to frame. Swing arm where bearings go. Front folks and clip on handle bolts etc.
If there is a manual or something I could buy I would be happy but am unsure where to look atm bar the obvious I.e. suzuki n harley shop or tss red baron.

[Katman]

The swing arm pivot nut is 73 Nm, the engine mount bolts are 65 Nm and the triple clamp pinch bolts are 23 Nm for the uppers and 28 Nm for the lowers.

[spoonguard]

thank you soo much!!! legend man.

[spoonguard]

also one other, are there any specs for the coilover and the pivots between the swing arm and the frame or is that just good tight?

[Katman]

Rear shock, top and bottom 50 Nm.

Cushion lever bolts 85 Nm.