Small end bush

[michaux]

Hi
Does anyone know who can make up a small end bush from the correct materials for a racing dirt bike engine (4 stroke)?
Thanks

[Oakie]

Oh. Read 'small end bush' and my mind went somewhere else. Carry on.

[Grumph]

Most competent general engineering shops should be able to make and fit a bronze bush - and even get the clearance close.
Icing on the cake is the ability to check the rod for twist and alignment.

[husaberg]

Hi
Does anyone know who can make up a small end bush from the correct materials for a racing dirt bike engine (4 stroke)?
Thanks

You can likely buy them ready made, Carrilo rods and others had bronze bushes std.
http://www.cp-carrillo.com/p-30878-rods.html
Aluminum/ Silicon/ Bronze
C642 Aluminum Bronze
Something less exotic is C932 Bearing Bronze .

What are the dimensions you are after?
http://www.aucklandbearings.co.nz/?action=search_type&types=5000

In Auck try this guy
http://www.kiwibiker.co.nz/forums/member.php/19368-RMS-eng

[Akzle]

re: Small end bush

thats nasty. Tell the bitch to shave

[husaberg]

Piss off out of threads about motorbikes and go back to animal porn.
http://hoeggerfarmyard.com/wp-content/uploads/2013/04/hoeggershear1.jpg