Zx10r

[Madmax]

just got the beast back!!!! it is a fucken jet
first gear wheel stands and such are a snap
was worth the wait, fully done engine
dam near parked it in a car at 200km doing a throttle
snap on
:niceone:

[Sniper]

Ouch mate, so you got any pics of the beastie.
Nice to see you are back and running

[bugjuice]

all back and running well then?
ain't a great start tho! Just mind it out there!!

[scooterboynz]

just got the beast back!!!! it is a fucken jet
first gear wheel stands and such are a snap
:niceone:
first gear wheel stands!!!! second and third are a snap too!

[Smorg]

fucking nice one bruuuuuvvvvaaa :headbang: :headbang: :headbang:

[WINJA]

AT LAST , I HOPE THEY GOT IT RIGHT THIS TIME, BTW YOUR WARRANTY SHOULD BE 24 MONTHS IN YOUR POCESION THEREFORE THE MONTH THEY HAD IT GETS TACKED ON THE END

[Madmax]

the bugger has picked up about 10-20 horse not that they
lack power to start off with,its just got power in spades now,
but i have to break it backin again

[gav]

whats been done to it?

[WINJA]

whats been done to it?
MIGHT HAVE AN EARLY HEAD ON IT , THE FIRST ZX10S IN NZ HAD DIFFERENT HEADS

[Madmax]

its been blueprinted and port matched cant wind it out past
5000 rpm for a bit (500km)but it pulls luck fuck from 4000rpm
and now sounds like a turbo winding up.
just playing round the block it will pop stands at 4500rpm
if you let it
(put the shits up one of my neighbours big time i went past his HSV like the his brakes were stuck on)
any ZX10R owners should get them checked for bearing noise
(it sounds like clutch rattle)
:devil2:

[scooterboynz]

good point mate , mine just has a whine in the gearbox which is due to the way the gears themselves are cut ? i read it in some mag somewhere,, no rattle which is good ,,, a mate of mine has just bought a lime green one ,,, sounds the same as mine which is good to hear ,,,,,