SV650

[TLDV8]

This is probably in the wrong forum and a long shot at that... but,does anyone in the Auckland area or say within a radius of Hamilton+ have a bare SV650 frame handy or one with a rearset removed (said it was a long shot)..i made these adapters but wanted to check if they fit ok before posting them...
<img src=http://photos.imageevent.com/tldv8/rearsetadapter/websize/RS37.JPG>

[FROSTY]

MAAAATE --gimme a yell-0210354615 --my race SV is in my gargre and I woulddnt mind pulling the pegs off-its only a 2 minute job

[Hoon]

.i made these adapters but wanted to check if they fit ok before posting them...

Nice! How much would you charge for making up a pair if I supplied you the hole spacings and offset (for a ZXR400)?

[WildBoarMouse]

Looks like you spent a while machining them! What do they do...? :)

[TLDV8]

MAAAATE --gimme a yell-0210354615 --my race SV is in my gargre and I woulddnt mind pulling the pegs off-its only a 2 minute job

Whoops, sorry Frosty..i had replied to the PM but hadn't noticed the replies here,thanks for the generous offer, i will give you a call :niceone: (just have to shoot out and do some more errands)
>
Hoon..i simply havn't got the time to do any more,these 2 brackets were started on Aug 21st and have only just finished them..fwiw, i never charge for any thing i make...i am a welder not a machinist so i take my time since it is only a hobby,enjoyment being the key word.

http://imageevent.com/tldv8/rearsetadapter

[Hoon]

http://imageevent.com/tldv8/rearsetadapter

Very impressive!! Didn't realise it was that much work.....no wonder rearsets are sooo expensive. If only I had a setup like that in my garage.........

[curious george]

Very nive TLDV8. i just need a rotary table to finish mine. Or a cnc machine.