Removing VIN plate to paint frame

[iranana]

Got an old bike here I'm restoring, and I'd like to remove the VIN plate to paint the frame. PO also went over the VIN plate with a wire brush, so I'd like to get a new one while I'm at it (but, to be honest, I don't really care all that much if getting a new one is a pain in the ass). Has anyone got any experience with removing/reattaching VIN plates, and having new ones re-issued?

[Black Knight]

Are they not just riveted on?-Drill out the rivet heads and re-revit-Sounds like a frog post:killingme

[Big Dog]

A quick giggle search got this thread. http://www.hondatwins.net/forums/showthread.php?t=22231

Sent from Tapatalk. DYAC

[Big Dog]

You may want to understand the legality before you get too far into the idea https://vehicleinspection.nzta.govt.nz/virms/light-vehicle-repair/vehicle-identification/vin-and-chassis-number

Sent from Tapatalk. DYAC

[YellowDog]

It's what crims go to jail for doing :buggerd:

[Voltaire]

drill out the rivetts, use dental floss to break the glue or they crumple, repaint and re rivet. I moved mine to behind the sidecover frame as lazy VTNZ tyre kicker put it out on the exposed frame.
Wof guy says" funny place to put it, have to take the cover off to see it" er....like opening a bonnet on a car?

[AllanB]

Ducati riveted one straight into the beautiful lines of the trellis frame. I have yet to forgive them for not placing it somewhere discrete like on the inside of the rear sub-frame or similar.

[Akzle]

http://tradetools.co.nz/products/4850460

:whistle:

also comes in handy with those out-of-test gas bottles...

[biggo]

Got an old bike here I'm restoring, and I'd like to remove the VIN plate to paint the frame. PO also went over the VIN plate with a wire brush, so I'd like to get a new one while I'm at it (but, to be honest, I don't really care all that much if getting a new one is a pain in the ass). Has anyone got any experience with removing/reattaching VIN plates, and having new ones re-issued?

If you have a 17 digit NZ Vin starting 7A........ you can get a new vin plate made by any entry certifier VTNZ etc. the cost is $75 for a VIN approval .

https://vehicleinspection.nzta.govt.nz/virms/entry-certification/reference-materials/vin-approval-request-form