PDA

View Full Version : Unfinished bucket racer!!



gav
12th February 2004, 12:25
Aren't they all?
Anyway this here is a home built (by prof m/cycle mechanic) box section alloy framed, mono shocked bucket racer. The motor is from a Yamaha DT100, has new Wiseco piston, and has been fully ported by a professional bike mechanic. It has a 28mm Mikuni flat slide carb aand has an expansion chamber built by Motorcycle Exhausts (Zorsts). It has a plastic YZ100 tank and a seat unit made up from an NSR250 seat pad and a VFR400R f/glass seat unit. It also has a steering dampner fitted. The rear wheel is an alloy rimmed XR200 unit, the front wheel and forks are from a GT125. It has home made clip ons.
Thats the good news, the bad news is it has been sitting in a gargae for at least ten years! It has run and been raced in the past, but not sure if it still goes but does have good spark and turns over OK. It needs bits like a chain, gear lever linkage, tank and seat unit secured etc, brakes need bleeding or cleaning (siezed?), needs front tyre but has good Yokohoma rear slick. Whats it worth? You tell me, like any race bike, it owes me an absolute fortune but would like to see it go to a good home and get it back on the race track.
Offers around $500.

Wheeliemonsta
2nd April 2004, 20:54
Gidday Gav,
Where abouts are you...??? Keen to have a look...
Regards
Wheeliemonsta\
Contact (027) 2427639 :bash: