RF900 specs

[Timber020]

Its xmas, im up visiting my folks and find dads got a killer mig welder sitting in his shed begging me to make a paddock stand for my RF900. Problem is that we took the car up and I cant find the specs on the net for the outside width of the swingarm or its height off the deck where the pit stand nuts are supposed to be mounted. Can anyone help?

[riffer]

Just measured mine.

Allow about 310mm minimum for swingarm width.

Height from ground to center of swingarm bobbin hole on mine is 285mm.

[Timber020]

Thanks!!!!!!!! Shall I make 2 or do you already have one? (that is if I can get enough steel)

[riffer]

Cheers Timber.

Got one already. :)