View Full Version : Exhaust Help
Vegan
20th March 2006, 15:40
I've removed the exhaust on my bike - I think i need to replace the exhaust wrap/padding on the join (the one in the middle under the belly with clamps) - is there a generic product I can get? or do I need a specific honda part etc?
sAsLEX
20th March 2006, 16:30
Explain with some pics maybe?
Vegan
20th March 2006, 16:40
These joins:
sAsLEX
20th March 2006, 16:46
So the exhaust part you have, the pipes are of slightly larger Diameter than the headers and have a short split in the end to allow slipping over the headers then a clamp of some description to close it up??
I used exhaust sealant on mine at the join to the last section, KK has been know to use a Lion Red can in there to help the seal.
Hope it helps, though take this advice with a spoon of salt
Ixion
20th March 2006, 16:59
From the look of it, Honda parts numbers 18291-MR8-000 and 18291-216-000. But check. Honda NC30 parts list here
http://x-files.serveftp.com/harkermaticwebspace/1nc30/ncarticles/manuals/nc30%20microfiche.pdf
EDIT: Uh not sure now. You say the "ones in the middle under the belly pan". But the picture , you indicate the header-> head . joint. The ones at the end of the front headers are 18391-310-000. Check the drawings at the above site.
Vegan
20th March 2006, 17:24
Ok Parts # 18391-310-000 - Muffler Packing according to that list.
Vegan
20th March 2006, 17:24
So the exhaust part you have, the pipes are of slightly larger Diameter than the headers and have a short split in the end to allow slipping over the headers then a clamp of some description to close it up??
Precisely. . .
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.