PDA

View Full Version : Changing Final drive ratio



masterofpuppets
1st June 2006, 18:29
well, it was about time i did the chain and sprockets on the zxr. i was not sure whether or not to go increasing the ratio or not. but then off to the shop i go and they say the only front sprocket we have is 1 tooth down. must have been fate fuckin with me. anyway, now one tooth lower on the front and it is such an unbelievable difference. the pick up in sixth gear is amazing. the acceleration from 100 to 160 ish is much much better than before, even though now i am limited to about 180, not 210. i know it doesnt compare much with your guys' 600s, but id definately recommend it for 250 owners.




muahahaha:rockon:

zeRax
1st June 2006, 18:44
;0...
hmm, id probably go up more on the back ;r

zeRax
1st June 2006, 18:44
no, down rather :P

gumby
1st June 2006, 18:47
Thanks for that bit of advice, I'm in need of new chain/sprockets so may go for a smaller one.

XTC
1st June 2006, 19:14
The only down side is you'll chew through more gas.

masterofpuppets
4th June 2006, 20:50
The only down side is you'll chew through more gas.

haha funny you should mention that cause i ran outta gas yesterday:doobey: . good thing i was riding with a mate. *note to self* fix the fuel tap so i atually have a reserve.........

N4CR
4th June 2006, 22:07
Speedo's only read to 190.. the needle stops. Did you stick a 400 speedo on it or something?

masterofpuppets
4th June 2006, 22:16
nah i just clocked it compared to a mate on a 600. this was back on boxing day headed up to wanganui. he said we were doing about 210. now i know there probably is a bit of difference in the accuraccy but 20k??

MSTRS
5th June 2006, 10:16
nah i just clocked it compared to a mate on a 600. this was back on boxing day headed up to wanganui. he said we were doing about 210. now i know there probably is a bit of difference in the accuraccy but 20k??
10% - not unusual