PDA

View Full Version : Paintjob request



Shazz
15th November 2006, 20:21
I am looking at getting a design on my tank, and rear fender.
I have found the one I like but don't know how to go about getting it off the net, getting it printed onto the right paper, and then getting it to a painter.
Any suggestions would be much appreciated.
Any suggestions on where to get a transfer done in the local area would also be great too.
cheers
:sunny:

Paul in NZ
16th November 2006, 08:34
To make a printable 'sticker' or transfer you need to find a hi res copy of it on the net because most net graphics are low/med res for fast loading and look 'grainy' when enlarged.

There is a place here in wellie (several in fact) that can make these graphics up on vinyl.

A low res copy is fine if you are going to get it air brushed onto the bike because the artist will be reinterpretting it any way.

Cheers

Shazz
25th November 2006, 18:30
thanks for that, much appreciated.
Guy is a tat artist and thinks he can do it ok.

Pixie
1st December 2006, 10:14
thanks for that, much appreciated.
Guy is a tat artist and thinks he can do it ok.

He'll need tungsten needles in his tatoo thingy to do a tank

Attract Promotions
1st December 2006, 14:00
hahhahhhaah,
Quote of the year!
Tungsten needles indeed :D