steve k
9th December 2006, 19:28
Ive got a kx 80 ignition for a bucket. What I am after is the advance angle that it should be set at BTDC.
i have been told that the ignition is set at 0.44mm BTDC on the KX80. This makes it about 10 degress BTDC.
Does anybody no if this is correct? I need to confirm this so I can calculate the setup for my MB100 motor. Have already chernobyled a couple of pistons so need to sort this out.
Any help would be much appreciated.
Cheers
i have been told that the ignition is set at 0.44mm BTDC on the KX80. This makes it about 10 degress BTDC.
Does anybody no if this is correct? I need to confirm this so I can calculate the setup for my MB100 motor. Have already chernobyled a couple of pistons so need to sort this out.
Any help would be much appreciated.
Cheers