Log in

View Full Version : Injected bike starting problems?



CBR97
3rd September 2007, 14:21
last nite, after a ride from hamilton I started to run out of gas, got to the gas station, bike ran out of gas as i pulled up.filled up rode home,2-3 min, as i got to my drive way bike stalled, and havnt been able to start ,
Ive never owned an injected bike, so anyone out there have any ides,s??
bike is a ZX12

imdying
3rd September 2007, 14:27
Does it make any attempt to fire, like cough cough at any stage whilst it's turning over, or is simply dead as?

CBR97
3rd September 2007, 14:31
it has backfired a couple of times, but this has been afyer trying to start bike for 30 to 40 sec, but mostly nothing at all

degrom
3rd September 2007, 15:07
This might be silly.. Have you turned off the ignition and turned it back on and tried stating it again. I know some of the Dukes won't start it you left the ignition on for more than 15 second without starting it.

Is your red Kill switch on or off?? (It happens I know... LOL)

johnnyflash
3rd September 2007, 15:41
A couple of thoughts, apart from those already checked,
1. Side stand up, out of gear, Kill switch on.. :-) I know, blindingly obvious BUT. :laugh:
2. When you turn on ignition do you hear the injector/fuel pump running up to pressure? (mine does) hear slight hum as it pumps up..
3. Is it definately Petrol in the tank? again I know its obvious :-)
4 you didnt per chance get a contaminated load of petrol/water from the SS, it happens...

CBR97
3rd September 2007, 18:32
As i havnt own a injected bike before, im no too sure on what has happened,
As i said the bike felt like it was running out of gas, the petrol gauge was on empty, bike was surging, felt like sumtimes there was very little gas then bike would pick up again.
as i pulled up to the pumps bike wouldnt idle.
fulled up tank, took a couple of attemps at starting bike then ran,

after about 20 to 30 seconds bike seemed to run rough,
as i pulled up to my drive way, bike stalled,
tried restarting, no luck.
left bike overnight,
tried again today, no luck.
backfired a couple of times, but doesnt sound if there is petrol, or spark.

turn key on, i can hear petrol pump working.

imdying
3rd September 2007, 19:16
Yeah buddy, you've got spark, otherwise you'd get no backfiring :)

Sounds like you've sucked the crap from the bottom of the tank (and by crap, probably just water).

Start with charging the battery whilst you undertake the other steps... a flat (or getting flat battery) will always foil attempts to make an unhappy engine go.

Drain the tank entirely, then fill it up with good gas. Not sure if a 12r is a recirc system, maybe someone else will. If it does return unused gas to the tank, then that should be enough to make it go, assuming you haven't murdered the plugs.

cowpoos
3rd September 2007, 20:07
bleed the fuel injection rail

CBR97
3rd September 2007, 20:26
:strange but true:

thanks for your help guys,
it seems that 2 things happened at once,

1. ran out of gas

2. muzzy timming unt unbolted it self, (or the dick who put it in hadnt done bolts up tight enough"
and that didk was .......me

thanks again for you help.

imdying
3rd September 2007, 21:23
Excellent, you all come back now ya hear :D

bimotabob
3rd September 2007, 21:54
Hi

'Don't run injected bikes out of gas" is a rule you should partake in - always.

Cheers

classic zed
17th September 2007, 13:19
Good to hear its fixed but as a note, on injected bikes as with injected cars the fuel runs through the pump cooling and lubing it, running out of fuel can stuff a pump in no time.

If there is not enough pressure because the pump output is low the bike will very often miss and be very sluggish.

Avoid running injected engines out of fuel.:2thumbsup