WANTED: HRC derestrictor for NC30

[Prof - R]

WANTED: HRC derestrictor for NC30 vfr400

HRC derestrictor for NC30 just like to find out if anyone has one of these or knows where to get one from

[montsta56]

From what I understand the HRC unit are near on Impossible to get. Plus you have to run full HRC loom.

[montsta56]

Were you just trying to derestict the speed limiter???

[Prof - R]

yip i just want to get the speed limiter off

[FilthyLuka]

yip i just want to get the speed limiter off

i can do it, if your non fixed location is near auckland, gimmie a PM

[Jamiepo]

Apparently you can add an 2.2 ohm into the circuit and this will cut out the speed limiter.

[more_fasterer]

From what I understand the HRC unit are near on Impossible to get. Plus you have to run full HRC loom.

That's the CDI, which gives more ignition advance at the top end.

The derestrictor is just that, plugs in in-line between the CDI and the loom. As it happens I just sold mine...

Have a search here (http://www.400greybike.co.uk) for ways to derestrict your bike

[FilthyLuka]

you can derestrict a NC30 with some pliers, search wikipedia for VFR400

[Chrislost]

just ahve to take that pesky speedo cable out and walla, redlining in 6th
dont unlug the speedo though, or the engine goes into "safe" or somthign adn runs like shit

[motorbyclist]

there's a tab inside the speedo, where once the needle hits the 180 mark it hits the tab and two cylinders stop firing to limit your speed

just bend the tab out of the way. problem solved.

it's on wikipedia