Carb for son's XL100?

[jed4czar]

Am after a carb for my sons xl100 about a mid 70's model I think. Would appreciate any advice or offers. Cheers

[bungbung]

Apart from wreckers, what about a carb from a chinese pitbike?
Mounting could be an issue however. The are pitbikes using an knock-off 110cc honda horizontal motor. Try here: http://newmanz.co.nz/zen/index.php?cPath=143&osCsid=ce3674262b5aef85624fa394907847c1

[barty5]

i have a box under house with all sorts a honda bits couple a carbs in there from memory not looked at it in 5-6 years ill see whats there may have been one of a 125 had some bits for one at one stage. Its yours if there is anything there.

[MyGSXF]

Give 'Baz Bikes' a call & see if they have anything.. 03 526 7175 :niceone:

Jen :rockon:

[B0000M]

what happened to the original carb? its fairly difficult to completely destroy a carb

[T.W.R]

You'll be after a 22mm Mikuni for a XL100, for a bit more zip a 24mm Mikuni off a XL125.

As for one off a Chinese bike :lol: you rip them off & throw away then put a Mikuni on if you want them to go somewhere near right

[jed4czar]

Apart from wreckers, what about a carb from a chinese pitbike?
Mounting could be an issue however. The are pitbikes using an knock-off 110cc honda horizontal motor. Try here: http://newmanz.co.nz/zen/index.php?cPath=143&osCsid=ce3674262b5aef85624fa394907847c1

Cheers - Tried that - bolted up ok but the jet needle / needle jet must be incorrect it barely runs with it!

[jed4czar]

i have a box under house with all sorts a honda bits couple a carbs in there from memory not looked at it in 5-6 years ill see whats there may have been one of a 125 had some bits for one at one stage. Its yours if there is anything there.

Thanks appreciate that.

[jed4czar]

what happened to the original carb? its fairly difficult to completely destroy a carb

Had a 2 stroke carb on it! didn't run (surprise) - the timing was hugely out as well. It's a bit of a strange one but the hardware is in good condition (he bought it off another young fella).

[jed4czar]

Give 'Baz Bikes' a call & see if they have anything.. 03 526 7175 :niceone:

Jen :rockon:

Ta - will do

[jed4czar]

You'll be after a 22mm Mikuni for a XL100, for a bit more zip a 24mm Mikuni off a XL125.

As for one off a Chinese bike :lol: you rip them off & throw away then put a Mikuni on if you want them to go somewhere near right

Thanks for the info.