Log in

View Full Version : Thread-locking compound?



HungusMaximist
7th April 2008, 17:05
After some non-permanent thread locking compound, since I've never bought any before I need some advice on this.

Cheers

Squiggles
7th April 2008, 17:22
http://en.wikipedia.org/wiki/Loctite

I only have red in my shed, need to get some blue

scumdog
7th April 2008, 17:27
http://en.wikipedia.org/wiki/Loctite

I only have red in my shed, need to get some blue

I've got 'wick-it' - red.

Applied after tightening up and but it wicks itself along the thread of the bolt to get between the threads.

HenryDorsetCase
7th April 2008, 17:28
here (http://www.loctite.com.au/int_henkel/loctite_au/binarydata/pdf/Loctite_AAM_Catalogue.pdf) is a link to the loctite catalogue.

Ive got 222 at home and some 642

one of those little bottles lasts forever in a DIY application.

HungusMaximist
8th April 2008, 07:48
Is there a good place I can get some?

The application is on 'bar end bolts', so a bit of the blue stuff or red stuff?

Hardwares stores like placemakers or Repco like stores?

And ah, what's this with the wicking?

YellowDog
8th April 2008, 08:47
I bought some last year from the Mitre 10 Superstore off the Wairu Road. I didn't realise there were so many different strengths and suspect I haven't used a heavy enough compound. Thanks to your post I have done lots of good web reading and will be replacing what I have used with the Pro stuff. Builders yards also sell it.

vifferman
8th April 2008, 08:53
Is there a good place I can get some?

The application is on 'bar end bolts', so a bit of the blue stuff or red stuff?

Hardwares stores like placemakers or Repco like stores?

And ah, what's this with the wicking?
If you need to remove the bar end bolts in the forseeable future, use blue, otherwise red.
You can buy it from Repco or any other autoparts or engineering supplies store.

glice
11th April 2008, 17:10
A cheap substitute is nail polish.

Henk
15th April 2008, 21:37
Getthe Red, I've never had a problem getting it undone, have used blue in the past as well with no problems. DON'T get the green.

Madness
15th April 2008, 21:45
222 for screws
242 for bolts & nuts
262 for studs

SKF have a shared master agency for N.Z.

HungusMaximist
16th April 2008, 20:43
A cheap substitute is nail polish.

Thanks, always up for some alternatives. :clap: