Carburator seals.

[Magua]

Does anyone have any or know of where I can get any, I rang red Baron and they want $56 for each one, plus the have to get them from Australia. Can't afford it, don't want to pay it.

[Motu]

They look pretty stuffed alright - I have repaired them with urethane,this is serious glazing grade stuff,not pissy silicon,seems to handle things in the fuel area,but maybe not direct contact.

[Bonez]

If you have no luck you could get a machine shop to make up the peice that attaches to the head, with tube for carb balencing. steping the edge to match the carb dia. O'ring on the face to seal it. And rubber tube from that to the carbs. Securing it with hose clamps.

[Magua]

Think I may bite the bullet and just buy them from Red baron, I'll ring around a few wreckers first though.

[riffer]

$56!!!!!!

Bloody highway robbery mate!

I had to replace the carbie intake rubbers on my fizzer and Maidstone Yamaha only charged me $15 each!

Check out other sources dude...