Fork seal alignment?

[Rupe]

I can't remember which side faces up with the new ones, anyone know?

[barty5]

I can't remember which side faces up with the new ones, anyone know?

its ok your bike is only rated 5 out of 10:niceone: put the seals in so the flatter surface is facin out the inner side will have a deepish groove in it and a spring that runs round the inside edge.

[barty5]

ps whats the stall count up to.:wari:

[Rupe]

its ok your bike is only rated 5 out of 10:.
Wanker!

So the flat surface faces the bottom/ground?????



I don't know the stall count as I only have 10 fingers

[barty5]

shit dont you have any toes poor bugger..

Yeh the flat surface should face down the length of the fork towards the outside.

[cheese]

Need some L plates mate?

tested that drill out?

[Rupe]

Need some L plates mate?

tested that drill out?

Yeah, maybe I could borrow them off your bike smart arse.

I'll give the drill a good run next week, cheers

[barty5]

Need some L plates mate?

tested that drill out?

im sure rupeert had some see pic:clap:

[Rupe]

im sure rupeert had some see pic:clap:

Anyone know how to give bad rep???? You got me there

[Hemex]

im sure rupeert had some see pic:clap:

hahahahha.. nicely done!!