Atlas
22nd September 2008, 16:18
Is anyone familiar with the 810 Dunstall Norton motors?
Have just been putting one together and was rather surprised that the circumference of the pistons are approx 3mm down the bore.
Almost as if the standard 750 norton rods are too short! At least the piston to valve clearances wont be an issue.:dodge:
Have just been putting one together and was rather surprised that the circumference of the pistons are approx 3mm down the bore.
Almost as if the standard 750 norton rods are too short! At least the piston to valve clearances wont be an issue.:dodge: